Many users will have a series of failure problems due to the non-compliance of installation conditions when using large-scale water softener equipment. So what are the conditions that need to be met to install a large-scale water softener plant?
The conditions that need to be met to install a large-scale water demineralized water plant are as follows:
1. The hardness of the source water ≤8mmol/L (if the hardness of the source water >8mmol/L, it needs to be redesigned);
2. The equipment should be installed on a firm cement platform, and there should be a drainage ditch nearby;
3. The salt tank should be placed close to the resin tank, and the length of the salt suction pipe should be shortened as much as possible;
4. Large-scale softened water equipment must be placed indoors, the ambient temperature should not be lower than 2 °C or higher than 50 °C, and the humidity should be less than 95%, which is limited to 25 °C;
5. The power supply is stable, the general value is 220V50Hz;
6. When the large-scale softened water equipment is directly connected to the heating equipment, the pipe section of more than 3 meters should be maintained and a check valve should be installed;
7. It should be convenient for the supplement of regenerant, which is industrial salt without iodization;
8. If underground well water or surface water is used as the water source for softened water, it is recommended that the user install a suitable fine filtration device in front of the equipment to prevent the resin from being polluted by deep well sediment or other impurities, resulting in a great reduction in the service life of the resin.
The above is the introduction of the conditions that need to be met when installing a large-scale demineralized water plant, so in order to use the effect of large-scale softened water equipment, we must pay attention to see if these installation conditions are met when installing a large-scale softened water plant!
